View and Download Philips HR 2303 instructions for use & recipes online. Frozen Dessert Maker. HR 2303 Ice Cream Maker pdf manual download. Also for: Hr2303/10, Hr2303/00. Philips or similarly qualified persons in order to avoid a hazard. When making ice cream, hygiene is of the utmost importance. Make sure that all parts of the ice-cream maker are entirely clean, especially the parts that come into contact with the ice. Properly and according to the instructions in this user manual, the appliance is safe to. View and Download Philips HR2304/70 user manual online. Philips Ice cream maker 20 W 1.0 l powerful cooling system. HR2304/70 Ice Cream Maker pdf manual download. Also for: Hr2304/10, Hr2304, Hr2304/02, Hr2304/00.
Release knob for removing the motor unit
from the cover
Release knob to detach the cover with
motor unit from the bowl
Cover (4822 441 80844)*
Aperture for filling
Stirrer (4822 690 40257)*
Cooling container (HR 2996)*
Bowl (4822 418 40897)*
* For replacement: please apply to your dealer
and refer to these numbers.
Tip: An extra cooling container (HR 2996) will
enable you to prepare larger quantities or two
How does the Ice-Cream Maker work?
The frozen cooling container is located inside the
bowl. This container quickly cools down the
mixture of ingredients, whilst the stirrer continues
to operate. The freezing mixture is stirred until it
has changed into ice-cream. The time this takes
depends greatly on the type of ice-cream mixture
Note: The cooling container is filled with a non-
toxic saline solution.
• Read the instructions for use in con-
junction with the illustrations (page 3)
before using the appliance.
• When making ice-cream, hygiene is of
utmost importance. Make sure that all
parts of the Ice-Cream Maker are
thoroughly clean: especially the parts
that come into contact with the mixture.
• Prevent the ingredients to freeze on to
the cooling container so that the stirrer
cannot rotate anymore.
- Only put ingredients into the container
while the stirrer is rotating.
- Do not switch off until the ice-cream is
• Never exceed the quantities indicated by
- Move the slide in the direction of the arrow and
turn the top of the Ice-Cream Maker in the
direction of the arrow (fig. 2).
- Pull the stirrer from the motor unit (fig. 3).
- Press the release knob and remove the motor
unit from the cover (fig. 4).
- Remove the cooling container from the bowl
• Ensure that the plug has been removed from
the mains socket, before starting to clean the
• Dismantle the Ice-Cream Maker completely
• Wash the cover (not the motor unit!), the stirrer
and the bowl in warm soapy water. Wash the
cooling container in lukewarm soapy water
(max. 40° C/100° F). (Do not wash these items
in a dishwasher.)
• The motor unit may be wiped clean with a damp
cloth. Never immerse the motor unit into water
Freezing the cooling container
Make sure that the cooling container is ready for
• The cooling container can be brought to
operating temperature in a (deep)freezer or in
the freezer compartment of
fridge. (Note: the cooling container must be at
-18° C / 0° F or colder.)
• On average it takes 18 hours to freeze the
cooling container down to the operating
• Ensure that the cooling container is clean and
dry prior to being frozen. Keep the cooling
container with the bottom downwards in a well-
closed plastic bag inside the deepfreezer: The
container will then always be ready for use.
• Do not place other objects on top of or against
the container whilst it is being frozen.
• Do not remove the cooling container from the
deepfreezer until the ingredients for ice-cream
have been prepared.
- Place the deep-frozen cooling container inside
the bowl (fig. 6).
- Insert the front edge of the motor unit into the
aperture (fig. 7).
Never immerse the motor unit in water nor rinse it under the tap.
The following accessories are available from your dealer:
Transparent lid (no. 4822 441 80844)
Stirrer (no. 4822 690 40258)
Cooling disc (no. HR2968 or no. 4822 511 90025)
Bowl (no. 4822 418 40898)
Tip: An extra cooling disc (HR2968) enables you to prepare larger quantities of ice cream or two
Do not throw away the appliance with the normal household waste at the end of its life, but
hand it in at an official collection point for recycling. By doing this, you help to preserve the
environment (Fig. 11).
guarantee & service
If you need information or if you have a problem, please visit the Philips website at www.philips.com
or contact the Philips Customer Care Centre in your country (you find its phone number in the
worldwide guarantee leaflet). If there is no Customer Care Centre in your country, go to your local
Philips dealer or contact the Service Department of Philips Domestic Appliances and Personal Care
If problems arise with your ice-cream maker and you cannot solve them with the information below,
please contact the nearest Philips service centre or the Philips Customer Care Centre in your
does not start
There is a connection
Check if the plug is inserted in the wall socket
properly. Remove the mains plug from the
wall socket and reinsert it.
The lid has not been
properly attached to the
Philips Ice Cream Maker Hr2302 Manual
Place the lid with motor unit on the bowl in
the correct position. Turn the lid clockwise
until it locks into place (‘click’).
The stirrer does
You put the mixture of
ingredients in the bowl
before you switched on the
appliance. This has caused the
ingredients to freeze onto
the cooling disc.
Always switch on the appliance before you
put the ingredients in the bowl.
The cooling disc
The cooling disc has frozen
onto the bottom and walls
of the bowl.
Let the cooling disc defrost for a few hours
until it has come loose from the bottom and
walls of the bowl. You can speed up this
process by pouring some lukewarm water
into the bowl.